-
First Time, Sorta . . .
So ive done the bubble bag method a few times before .... with pretty good sucess, very tan no green etc....never tried to 'melt' it, but it was potent....
anway, this will be i first time with a lot of trim, not sure of the total weight but it feels like 20-30 pounds...contractor bag, full of wet purple urple.
With a 3 bag, 5 gallon set up .. what kind of yeild can i expect to get.
and how much wet product should i be putting in for each run.
and god im annoying....last 2 questions, with using a drill and a paint mixing tip how long should i mix it, and if you remix the the first bag with fresh ice and water will you get any thing else out of it?
thanks in advance
23north
-
You might wanna consider getting a bubblenow, which will mix it for you. A paint mixer might cause too much contamination so perhaps try a wooden spoon. If you choose the drill w/paint mixer attachment, put it on the lowest setting.
15 minutes would be a good amount of time to mix.
Also, you can usually do a second run, but it will result in lower quality