Hey guys haven't posted to much because I have just been reading about bubble info. My friend finally got a hold of some bags and trim so he did his first run and I thought I should share some of the end results with you guys to see what you think. The bubble is good and some of it is in fact full melt, but I have a question about his methods. He told me that after it was chopped up on cardboard for a day that he put it on the cardboard in the freezer. Wouldn't that just freeze the water into the bubble? He said he read a thread about "cryogenic hash" on another forum but I have been reading on this forum for a while and haven't seen anything of the sort. Although I have also heard that freezers suck the moisture out whats in it(not sure if that's true though). In anycase to my understanding you should lightly press the bubble on the pressing screen with a paper towel. Then you should chop it up finley and let it dry for atleast 3 days. then put it in a glass jar and let it sit for a bit. I beleive bubble is suppose to harden up when it is not heated by the warmth of your hand or a flame, but this bubble is quite plyable without very much heat needed. It makes me think that there is still some water left in it, so I better use it before it gets moldy since he already pressed it all. I will have to get some melty pics up a littler later. This pictures are a mix of the 25 and 73 micron.