Cleaning Percs

[govegan]

What's everybody's best method to clean percs? They're always such a bitch to get spotless, I feel like no matter how much grunge off one uses on them, there is almost always atleast a thin layer of scum left on them. Fucking A.

[YukonBikerGuy]

I use 99% isopropyl alcohol and table salt combined with a lot of shaking.

[winspence3]

Ok man, I had the same prob. for a long time. There would always be this thin ass layer of discolor inside the perc chamber. I tried everything, hot water, iso, different salts ect. Finally I saw on TC that someone had used oxyclean and worked. Sure

[winspence3]

So just fillup you tube full with hot water, plug up the hole with stopper, dump in a scoop of oxy and let it do it's thing. The longer you let it just sit and shake it around every once in a while, the better the product works and will just lossen everything in the tube off. Then I just run mass hot water and then cold water.Works like a charm everytime. Let it sit for and hour or so if you can. Hope this helps!

[winspence3]

Those really thin layers come off as skin like layers sometimes, it's looks really gross but then again your tube is spotless and nothing looks more gross than a dirty ass bong!

[govegan]

So far I've blown threw a bottle of Grunge Off and two bottles of iso propo and countless amounts of salt... but oxyclean, now that seems like a solution that I never thought of. Thanks everybody. Bong scum is fucking gross

[Doomtrain]

What is the word on using Oxyclean to clean?

[trevorlahey]

Heat up the iso on the stove it works 1000% better just be careful, apparently that stuff is flammable.

[Radio Flyer]

ISO WILL BLOW UP IF HEATED TO LONG.

ISO has a VERY LOW BOILING POINT so be EXTREMELY careful when heating it.

[DaNK]

I have a 7-13 arm toro and I use Grunge off super soak. It comes in the black bottle. takes less than 10 minutes and its like new again. The key is not going too long in between cleanings. peace, hope this works out for you!