Refining Dry Sift Hash Using Bubblebags
I've been thinking about doing this for a long time and I finally got to do it.
Refining dry sift hash through the Bubblebags system!
Where I currently live in the middle-east it's common to get dry sift hash more than any other form of cannabis. Usually the same seller provides you good, mediocre and even unsmokable product depending on what he has available at the time. The most popular local smoking method is to press the powder hash and then roll it with tobacco. For someone who doesn't smoke tobacco such as myself, it's out of question. I've been smoking it mainly through bong hits and it's fine. However, I really miss the quality bubble hash I used to get. So here goes my first trial at refining the quality of hash and separating it into different micron sizes.
Please comment on any improvements I could make.
I've started with 25 gr of material acquired for around $120 and the 1 gallon Bubblebags system.
I crumbled and loaded it into the system with water and some ice cubes
I did some manual mixing and my friend thought about using an electrical mixer to break it all down. After the mixer was used for around a minute or two, there was almost like a milky foam look to the liquid.
We waited around 20 minutes for the material to settle down
Once we started pulling the bags the most material was stuck in the 220 working bag. I know that with buds, this is what we toss but the amount of material and this being an experiment made me wanna keep it.
It seems like the hash is indica dominant, I didn't get much in the lower micron sizes below 120.
The water that was left after all the bags were pulled had some sediments sitting in it. I believe these to be dust and other contaminants.
I will report back on the smoke test once everything is dry.
Reply With Quote