Results 1 to 10 of 52

Thread: Sulphur plasma lighting

Threaded View

  1. #19
    Join Date
    Dec 2007
    Location
    BC
    Posts
    81

    Default

    Adding some co2, a new setup from Supernatural using the excellofizz pucks called the Excellowizard. Used the pucks before but was just dropping 1 in the water when I went into the room, so it was a quick blast of co2 without any regulation.
    This new setup works by displacing water with an airpump, so on a timer it doesn't waste when the lights are off. The instuctions say it should fill a 10' x 10' room to approx. 1500ppm when run for 15 minutes, I'm trying out 15 minutes on every 2 hours. I'll have to grab the regulator & sniffer out of the other room to see how it does & get it dialed in.
    Yes I noticed how dirty the old fan is, I'll have to clean it off tonight so I'm not blowing dust all over the girls...

    Edit: Timer is set for 15 m every 2 hours not 1
    Attached Images Attached Images
    Last edited by FtW; 07-06-2008 at 12:06 AM.

Similar Threads

  1. Lighting question
    By crAZjoeherbizzle86 in forum Indoor
    Replies: 6
    Last Post: 01-01-2010, 07:26 AM
  2. Lighting question
    By fizoster in forum Indoor
    Replies: 9
    Last Post: 02-18-2009, 03:16 PM
  3. new plasma bulbe
    By Clear_Dome in forum Indoor
    Replies: 1
    Last Post: 04-23-2008, 10:05 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •